MDS MDS iNET 900 Dokumentacja Pobierz pdf (Strona 20)

18 iNET Series Installation & Start-Up MDS 05-2873A01, Rev. E

Cannot access the

MS through COM1

a. Connect to unit via Telnet or Web browser

b. Disable the serial mode for COM1

(Serial Gateway Configuration>Com1 Serial

Data Port>Status>Disabled)

or, if you know the unit’s data configuration...

c. Connect to COM 1 via a terminal set to VT100

and the port’s data baud rate.

d. Type “+++ [ENTER]”

e. Change the terminal’s baud rate to match the

transceiver’s Console Baud Rate.

f. Type “+++ [ENTER]”

Cannot pass IP

data to WAN.

a. Verify your IP settings.

b. Use the PING command to test communication

with units in the local radio system.

c. If successful with local PING, attempt to PING an

IP unit attached to another radio.

d. If successful with the LAN PINGs, try connecting

to a known unit in the WAN.

Wireless Retries

too high.

Possible Radio Frequency Interference—

a. If omnidirectional antennas are used, consider

changing to directional antennas. This will often

limit interference to and from other stations.

b. Try skipping zones where persistent interference

is known or suspected.

c. The installation of a filter in the antenna feedline

may be necessary. Consult the factory for further

assistance.

Password

forgotten.

a. Connect to the unit using a terminal through the

COM1 Port.

b. Consult the factory. Get a password-resetting

Authorization Key.

c. Enter the Authorization Key at the login prompt

as a password.

Table 6. Troubleshooting with the Menu System

Symptom Problem/Recommended System Checks

1 2 ... 15 16 17 18 19 20 21 22 23 24

Komentarze do niniejszej Instrukcji

Brak uwag

MDS MDS iNET 900 Dokumentacja Strona 20

Komentarze do niniejszej Instrukcji

Clarion appareil photos de pont manuels d'utilisation